Philips steam generator repair

Philips steam generators are in great demand among modern consumers. These functional devices are presented in a large assortment. The attention of users of this technique attracts the highest quality. Philips original devices are durable, reliable and attractive, but this does not mean that they cannot break. In this article we will learn how to properly repair branded steam generators in case of various breakdowns.

Even the highest quality and most reliable steam generator produced under a well-known brand can break. Breakdowns are different - small and large.

Check out their list.

You will need:

• set flat and cross screwdrivers;
• wide knife or an unnecessary plastic card, or special tool for removing parts on latches (with a knife, the case of the steam generator can be accidentally scratched, thereby spoiling its appearance);
• multimeter - this is a device that will be necessary in order to ensure the integrity of all important elements of the device being repaired;
• may be necessary and soldering ironif you need to change certain parts.

In addition to tools, the following can be useful for repairing equipment materials:

• insulating tape;
• special heat shrink tubes;
• pliers;
• piece of sandpaper.

All tools for work should be high-quality, reliable and intact.

Philips steam generators can suffer from various types of breakdowns. Most problems can be handled without the help of specialists. Let's look at some examples. common breakdowns and ways self-repair of similar equipment.

It happens that the steam generator during its operation does not produce the necessary steam. Possible reasons may include the following circumstances.

• The device is clogged with scale. To remove the scale, you need to clean the equipment. The lion's share of models produced by the brand are equipped with an automatic lime removal function - smart calc-clean (when descaling is required, De-Calc button flashes and usually a red or orange light is on). To do this, pour water into the device, turn it on, and then press the corresponding button. After a couple of hours, the liquid must be drained by rinsing the boiler again. Some models will have to change cartridges.
• The key responsible for supplying steam was not pressed. To solve the indicated problem, press the button and press until the unit starts working.
• The device has not completely warmed up. Often people mistakenly believe that the unit has stopped issuing steam. In fact, this technique heats up for 2 minutes after starting, after which the steam still goes on.
• There is little water in the boiler. If the device does not produce steam, there may be a lack of fluid in its tank. It will be possible to solve this problem by adding water to the desired level.

The Philips branded steam generator may not turn on for the following reasons.

• Damaged power cord. If there are no noticeable defects, it is difficult to find the punctured area. Have to consult a specialist.
• There is no power on the network. To check the correct operation of the outlet, you need to include any other device in it.
• The power-on indication does not work when the equipment is working properly. You will need to press the button that feeds steam to check the operation.
• Failure in the actions of electronics. In this case, you need to visit an experienced master.

If liquid leaks from the steam generator, reasons may be as follows.

• Condensation has accumulated in the steam hose. The problem that occurs after a long downtime. You can solve the problem by pointing the sole of the iron to the side while holding the steam key until the water turns to flow. It is also recommended to check the condition of the hose for kinks or clamps.
• Water with aromatic additives or impurities was poured into the container. In this case, the boiler must be flushed. Then clean water is poured into it again and the device is started.
• Frequent activation of the steam boost function. The technique can be used further, but wait a little before the next pressing the button for intensive steam supply.
• After cleaning the equipment, water still remained in it. It is she who can flow out of the sole. It is only necessary to wipe it with a dry woven rag.
• The shutter valve is broken. It must be replaced.
• The holes are clogged with scale. Will need cleaning.

The following may cause this problem.

• The device was charged with contaminated water. In this case, flushing the tank is required.
• They did not use the equipment for a long time, but a little liquid remained inside. The boiler must also be washed thoroughly.
• TEN has failed. It will need to be replaced.

There may be other problems with the Philips steam generator.

• The device may alternately or simultaneously flash blue and green lights. Most often, with such a malfunction, the equipment is sent to a service center. This breakdown is associated with damage to the yellow wire in the design of the device.
• It happens that the steam generator beeps and at the same time the Orange Anti-Calc indicator is lit on it. Perhaps the fact is that the descaling cartridge has become unusable. If the signals continue after replacing it, it is worth taking out and reinserting a new cartridge again. Replacement should be made only after disconnecting the equipment from the network.
• The above signals can be shown every 2 weeks. In this case, repairing products is simple - you need to tighten the cartridges inside the devices.

If the steam generator breaks down, the cause may be breakdown of the electromagnetic coil.

You can disassemble and assemble damaged equipment like this.

• Unit first disconnects from the network.
• Protective rubber bands from the steam station, unscrew the bolts above it.
• The top cover is removed. Under it there is an upper body part, fixed by 3 screws. They need to be unscrewed.
• Having removed the case, you can see the coil. It must be replaced. It is mounted on just one nut.
• Back assemble the equipment you need exactly the samebut in reverse order.

Of course, there are no guarantees that the Philips branded steam generator has failed due to the need to replace the electromagnetic coil. Probably, the problem lies in other important details of household appliances.

Having a Philips steam generator at home, you need to be prepared for the fact that for some reason it can break (like any other equipment).

In this case, it would be better if you arm yourself with a few useful tips and tricks.

• Do not be afraid when the steam generator delivers steam with a slight delay during first use. In these seconds, the equipment is working properly, but just getting ready for further action.
• To prevent hot sprays from the steam generator from getting on the skin while eliminating leaks, keep the device away from youabout until the problem is completely resolved.
• The operability of many details can be checked even in the store at the stage of purchasing equipment. Usually, sales consultants do not refuse buyers such a request.
• If the breakdown is too complicated and serious, and you do not have the relevant experience and knowledge, it is better not to waste time in vain and not try to fix everything yourself, but visit professional craftsmen. Otherwise, you risk only making things worse and breaking the generator.
• When disassembling a branded steam generator, you should be as careful as possible. Try not to damage the case, as it can easily leave chips or scratches on it, especially if you open it with sharp tools.
• If the device of the branded steam generator does not provide for “smart cleaning system”, mentioned above then you can get rid of scale in the tank with citric acid. It also easily dissolves mineral deposits on the sole.
• If there are severe blockages in the steam generator chamber, due to which steam is not supplied, self-repair is not recommended. It would be more correct to visit the service center.
• You can never encounter many breakdowns and problems of branded equipment if you use it correctly and carefully. Operate the steam generator in accordance with the instructions, treat it carefully.

See the video on repairing a Philips steam generator.